Grand Rapids Remodeling | Installing Pre-made Glass Block Basement Windows
Posted: Tuesday, January 19, 2010
by Paul Bilodeau
Grand Rapids Remodeling
Natural light in a basement is a priceless commodity. Home builders of old recognized this and integrated hopper windows in basements. They were normally the size of four standard cement blocks (16" X 32"). Grand Rapids Remodeling has found these windows were steel framed and mortared in place. Unfortunately, they also can let in cold air and unwanted guests. Pre-made glass block windows can be installed to retain the valuable natural light and be a beautiful safe solution to the non efficient hoppers.
Shims (composite)
Expansion foam
1 Bag of mortar
5 gal. bucket
Margin trowel
Access to water
Silicone
4" Glass block "C" channel (commonly found in the glass block aisle)
1 " screws
Screw gun
Safety glasses
Gloves
Step ladder
Torpedo level
Small piece of batt insulation
Vacuum
With the removal of the old window complete, the do-it yourselfer should be looking at a clear opening in the side of a basement wall. The board at the top of the opening is called a sill plate. This is where you will screw the "C" channel into. If the "C" channel needs to be cut down to size, it should be done now. The material is a PVC product that is readily cut to size using a hand saw. Care should be taken to position the channel correctly. It is best to position the "C" channel in the center of the opening and flush with the outside wall. It isn't always possible to install flush with the outside wall. That's OK, just try to get it as close as possible. Cut the batt insulation to fit in the "C" channel and to the width of the glass block, (aprox. 4" X 32") and set the shims in a handy place. Two people are needed to set the window up in the "C" channel, insuring that the insulation stays in between the "C" and the window. If the unit contains a window, make sure the window is right side out. The window screen and weeps should be outside and a window, make sure the window is right side out. The window screen and weeps should be outside and the locking hardware should be inside. Place the shims under the window, keeping the window snug in the channel. The torpedo level is now used to level and plumb the unit. Use the vacuum to remove dust and debris from the opening, and then fill the voids on the sides and bottom with expansion foam. Be careful not to over do it. A little goes a long way, and you do not want to completely fill the void with the foam. As the foam expands, it adds "R" value and helps hold the unit in place. Congratulations! You can now clean up and wait for the expansion foam to do its work overnight.
Upon returning the next morning, cut any excess expansion foam flush with the window. Mix the mortar with water in the 5 gallon bucket to a peanut butter consistency. Mortar is applied over the expansion foam and packed around the perimeter of the glass block with the margin trowel on both sides of the window. This is the strength that holds the unit in place. If the glass block is not flush with the existing wall, the sill must be angled to shed precipitation on both sides of the unit. It will take a little practice to get the mortar right. Any Grand Rapids remodeling contractor knows, the less you play with it the more it will do what you want. If the mortar "sags", let it go and come back after its set up but still "green." Shave any excess off with the trowel and smooth the surface. Finally, seal around the "C" channel and the sill plate with silicone at both the interior and exterior for a watertight seal. The mortar will set up and harden in the next 24 hours. A sponge or a moist rag can take off any excess mortar that inadvertently got on the glass.
This Article has been viewed 937 times. (Not updated in real-time.)
Top-level comments on this article: (1 total)Nice article, very helpful!!
We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.